Adding a node to cluster

    Manually run the cluster setup wizard to add the node to the cluster .This is exactly the same procedure you would follow to add even more nodes to the cluster, the only differences being that you would assign a different the IP address and possibly a different management interface port name.

Step:1

Launch a Putty section and type Cluster setup command,

Step:2

It ask's you want to create a new cluster or join an existing cluster, type "join", and it will show you the existing cluster interface configuration. If you want to use the same existing cluster configuration then type "yes"

Step:3

Here it will ask a cluster name in which you want to add a node. just hit enter,

Step:4

In this step need to configure SFO (Storage failover) if you use HA system. As we dont have HA cannot configure SFO.

Step:5

In this step need to configure the Node, assinging IP,Interface,Gateway..etc.

That's it. Successfully added a node to cluster1.